+Ray Kholodovsky Thanks for you assistance navigating this - and for providing a solution.This is a 5 megapixel (2592 x 1944) USB camera, configured by the manufacturer for use with LightBurn, and will work equally well on Windows or Mac systems. We can send you a replacement - please send us an email or fill out the contact form on the website with your order # and reference to this thread. Wiring pics (from power supply to C3D Mini) 1/5Īfter leaving it for a while, powered down, computer, laser cutter, etc, powering back on - there is zero movement possible now using the C3D mini board. Switching back to the cohesion 3d Mini, (with everything powered down), full reboots of computer… Reconnecting the stock board, the Y axis works correctly. Hitting home pushes the head far left (correct), but keeps doing so for that 10+ seconds, even if homes again right after homing once. +Ray Kholodovsky I have tried absolute positioning. When I hit HOME, it homes the X, though doesn’t recognize when to stop and spends 10-20 seconds vibrating like crazy trying to go beyond where physically possible (moving left). I still have zero motion in my Y positioning (from starting a program or using the direction controls in lightburn). +Ray Kholodovsky My mistake, I can now control my X position in lightburn. It is intermittently controlling the X position (not by the movement controls in lightburn, though, but by having it START a small design. Rebooted it (powering down, unplugging USB).
I get this in the console, and then nothing while it finishes sending.Ĭhange Start From, from current position to absolute coordinates. +Ray Kholodovsky Switching the port from auto to Com 8 (the suggested one) lets me get a bit farther, but still no motion occurring. +Ray Kholodovsky I’ve switched between 3 different USB cords, including the stock. +Ray Kholodovsky I used my 32GB card (not a permanent solution), and now have all lights as expected.Įrror:Alarm lock is constant in the console, and I can’t move anything via lightburn.Īre you using the stock K40 USB Cable? Don’t. Do you have a different card you can try to use? Just need to format it FAT32 and put the config and firmware files on it - these are located in a dropbox at the bottom of the install guide. If I remove it an check it on my computer, it will not read the card. I can’t read it at all on my computer, though. (My K40 uses the connections shown here: and I’ve plugged the 3 plugs in and the USB as shown in this image)
Sage advice and wisdom is much appreciated! Using a backup power-supply sees the exact same thing happening. Without the K40 powered on (only USB), the same things happen, without the VMOT lighting up. I’ve just installed the Cohesion 3d Mini in my K40.ģV3 solid green (very hard to see as VMOT red is so bright)
0 kommentar(er)
